Top Ranked Tips For Concrete Polishing
Among the industries that have evolved at a rapid speed is the polishing industry. This industry has many companies that have grown and others starting now. With time, many other companies will keep coming up due to large population getting interested in this industry. Quality concrete polishing can be done with the companies that apply the tips contained in this article. The tips are explained well below.
Determining the surface hardness is the first thing that should be done. A concrete hardness tester is the tool that is used for testing concrete hardness. This is to help in deciding on the right abrasives. The surface then is scratched with the use of the tip number nine. Then, in a descending order, the scratching is done. This is done until the tip cannot do the scratching anymore. At this level, the hardness is ok now.
Then the preparation of the concrete surface is done as the next thing. Some floors for concrete polishing are coated. In this case, the right tools should be used in the removal of the coating. The type of coating is what affects the equipment to be used in the removal of this coat. Some floors normally have cracks and holes. The repairing of this holes and cracks should be done first. The next thing that should be done is gritting with the metal bond tooling to the level and flatness that is desired.
Then the metal tool marks have to be removed. Transitional tooling can help here. The marks made by the tool can be removed very well with the use of transitional tooling. The process is considered successful when all the tool marks disappear.
Then the floor is densified and hardened by vacuuming it. The pore and crack filer is used to densify and solidify the surface of the floor. It also helps in protecting the floor from water penetration and creation of stains. A lot of care is needed so as the pooling does not result when using the floor densifiers. This is because the stains caused by poling can result to the stains that can make polishing hard to do.
Then now the polishing is done after all the above things are complete. Resign band tooling is appropriate to start with. Then all the dust is removed that is, the space is vacuumed in between the passes. Then the floor is burnished with a burnishing pad after the final grit level is achieved.
Then for protecting is done as the last thing. The protection is done by sealing the floor. Some of the things that the floor is protected from are the grease, oil and any other chemicals. The floor sealer is bet applied with the use of the pump. To leave the floor shining, burnishing is essential. Successful concrete polishing can be done with the tips given.